Your basket

Total: £0.00 View

‘How to Measure’ for your sliding wardrobe doors

Important: Please remember, we always need the MINIMUM height dimension of A, B or C. Measure carefully, so we don’t make your doors too big. Use the Maximum of width D or E (this is less critical than the height). If in doubt call or email us with your questions.

Option 1: Fitting Floor to Ceiling and Wall to Wall:

This is the easiest to measure and install. If you have skirting’s, you will need to remove a portion where the doors touch the wall, or install wall liners as in ‘Option 2’.

Option 2: Using Floor and Wall Liners

We recommend this if you walls are not vertical, and floor is not flat (or if you are installing, or have, carpet). We can supply wall and floor liners in 18mm MFC in most colours. Pack out the liners to create vertical and horizontal surfaces. Calculate your measurements from inside the liners.

Option 3: Wall to End Panels

We have a range of 18mm MFC end panels, or alternatively, use MDF and decorate to exactly match your wall colour. End panels can be used in conjunction with ‘Wall and Floor Liners’ as shown in Option 2.

Option 4: Using Infill’s

For Openings Wider than 4555mm (Made to Measure Doors) or 3607mm (Standard Doors). Contact us direct for openings up to 5000mm as this is now possible.

Only do this if your opening is wider than our widest track length. Infill’s can be placed on the left and right to centre your wardrobe. Again, we recommend MDF and decorate to match you walls, or use our range of end panels. Infill’s can be used in conjunction with ‘Wall and Floor Liners’ as shown in Option 2.

Option 5: Reducing Ceiling Height

For ceilings higher than 2450mm (Made to Measure Doors) or 2260mm (Standard sized doors)

Again we recommend a timber and/or MDF construction, decorated to match your walls, or use our range of MFC end panels or floor liners. Ceiling reduction can also be used in conjunction with ‘Wall and Floor Liners’ as shown in option 2.

Option 6: Angled Ceiling

For angled ceilings, order the ‘S9 Angled’ Made to Measure Sliding Wardrobe Doors.

Due to the nature of the S9 series angled wardrobe doors, we need you to take additional measurements in order for us to manufacture your doors to fit the opening.

Here, measurement A is the height from the floor to the base of the angled section (referred to within the design tool as ‘Short Height’) and measurement D is the width of the opening at the ceiling (between the tall wall, and where the angled section meets the ceiling – this is referred to in the design tool as ‘Ceiling Width’). The smallest of measurements B and C, and the largest of measurements E and F are the ‘height’ and ‘width’ of your opening respectively.

Scribe and Return Measurements

Scribe and returns do the same job as wall liners (or strike plates), but they are much thicker, allowing you to cut (or scribe) them around skirting boards, picture rails, cornicing, uneven walls, or any other obstacles. Although they are over 100mm wide (most colours are either 108mm or 118mm wide), they are normally cut down during installation. Our design tool assumes that you will cut them down to 80mm, but it’s completely up to you.

Again, make sure you calculate the door opening width from the INSIDE of the liners. For example if your wall to wall dimension is 3000mm, then your opening width will be 3000 – 80 – 80 = 2840mm (assuming your cutting down the scribe & returns to 80mm each).